Restoring The Original Configuration; Use And Maintenance; Up And Down Buttons; Stop Function - SOMFY Sonesse 50 RTS Manual De Instalacion Y Uso

EN

2.4.3. Restoring the original configuration

Only switch off the power to the application to

be reset.
This reset deletes all control points, all the sensors
and all the end limit settings, and resets the motor's

favourite position (my).

Position the motorised product at the mid-height
1)
position.
Cut the power supply for 2 seconds.
2)
Switch the power supply back on for 5 to 15
3)
seconds.
Cut the power supply for 2 seconds.
4)
Switch the power supply back on: the motorised
5)
product moves for a few seconds. (If the application
is at the upper or lower end limit, it will make a brief
up and down movement).
Press the PROG button on the Somfy local
6)
control point for ≈ 7 seconds, until the motorised
product moves up and down twice:
The motorisation is reset to the original
→
configuration.
Repeat the commissioning
-
commissioning) section.

3. USE aND MaINTENaNcE

This drive is maintenance-free

3.1. Up aND DoWN BUTToNS

Λ V
Pressing the or
motorised product.

3.2. STop FUNcTIoN

The motorised product is moving.
Briefly press my: the motorised product stops
-
automatically.
3.3. FaVoURITE poSITIoN (my)
Besides the upper and lower positions, an
intermediate position known as the "favourite position
(my)" is programmed as standard in the Sonesse 50.
To use the favourite position (my):
Briefly press my: the motorised product starts to
-
move, and stops in the favourite position (my).
To modify or delete the favourite (my) position, see
the section entitled "Additional settings".
18
procedure
PROG.
button fully raises or lowers the
Images not contractually binding
1)
3)
5)
6)
(see
PROG.
A
PROG.
B
B
PROG.
B
1)
2)
3)
Copyright © 2014 Somfy SAS. All rights reserved.
2)
4)
PROG.
PROG.
B
B
A
B
MY
A
X 2
A
A
A
A
C