Bruno SRE-3000 Manual Del Operador página 8

OPERATION: standard swivel seat and power swivel seat (optional)
STANDARD SWIVEL SEAT (continued)
POWER SWIVEL SEAT (optional)
©Bruno Independent Living Aids, Inc.
8
®
8. Position both feet securely on the footrest
and place your arms on the armrests.
9. Press and hold the rocker control switch
(located on the front edge of one of the
armrests) to travel UP / DOWN the rail.
10. Once you have reached the top or bottom
landing, release the rocker switch.
11. Depress and hold the seat swivel lever as
you rotate to the position for transferring
from the seat.
NOTE: The seat will only swivel at the
top landing.
12. Release the seat swivel lever and allow
the seat to lock in this position.
13. Unbuckle the positioning belt and carefully
exit the seat.
1. Position yourself in the seat.
2. Fasten the positioning belt.
3. Position both feet securely on the footrest
and place your arms on the armrests.
4. Press and hold the rocker switch (located
on the front edge of one of the armrests)
to travel UP / DOWN the rail.
5. Once you have reached the top or bottom
landing, release the rocker switch.
6. To rotate the seat at the top landing,
press the rocker switch again on the
same side.
7. Release the rocker switch when you have
fully rotated out.
8. Unbuckle the positioning belt and carefully
exit the seat.
NOTES:
• You may use the remote call/send
transmitters to return the rotated power
seat back to the ride position.
• If the unit stops unexpectedly while
traveling, check for obstructions or
excessive loading. You will only be able
to run the unit in the opposite direction
until the overload is cleared.
SRE-3000 OPERATOR 12 JUNE 2017