Setting The Torque; Switching On And Off - Hilti SFE 2-A12 Manual De Instrucciones Original

6.2 Setting the torque

The torque is limited only when the power tool is set to screwdriving
mode .
▶ Turn the adjusting ring to the desired torque setting.
6.3 Switching between forward (clockwise) and reverse rotation
(counter-clockwise)
An interlock prevents switching while the motor is running. The control
switch is locked when the forward/reverse switch is in the middle
position (safety lock).
1. Operate the forward/reverse switch.
➥ The switch-on safety lock is active.
2. Operate the forward/reverse switch.
➥ The direction of rotation is set as desired.

6.4 Switching on and off

1. Press the control switch.
➥ The power tool starts.
Speed can be controlled steplessly right up to maximum by varying
how far the control switch is pressed in.
2. Release the control switch.
➥ The power tool switches off.
6.5 Screwdriving
1. Set the torque. → page 12
2. Set the direction of rotation to forward (clockwise) or reverse (counter-
clockwise). → page 12
3. Press the control switch. → page 12
6.6 Drilling
1. Set the torque setting ring to the
2. Set the direction of rotation to forward (clockwise). → page 12
3. Press the control switch. → page 12
12 English
Printed: 07.08.2019 | Doc-Nr: PUB / 5507951 / 000 / 00
2
symbol.
2236949
*2236949*