Finish Cooking - EAS ELECTRIC EMIH290-FX Manual De Instrucciones

Place a suitable pan on the cooking zone that you wish to use.
• Make sure the bottom of the pan and the surface of the
cooking zone are clean and dry.
Touching the heating zone selection control, and an indicator
next to the key will flash
Select a heat setting by touching the slider control
• If you don't choose a heat setting within 1 minute, the
Induction hob will automatically switch off. You will need to
start again at step 1.
• You can modify the heat setting at any time during
cooking.
If the display flashes
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 2 minutes if no suitable pan is placed on it.

3.3.2 Finish cooking

Touching the heating zone selection control that you wish
to switch off.
Turn the cooking zone off by touching the slider to "○".
Make sure the display shows "0".
Turn the whole cooktop off by touching the ON/OFF
control.
alternately with the heat setting
11
power up
power down
V.2