Finish Cooking; Using The Boost Function - EAS ELECTRIC EMIH290-3S Manual

Select a heat setting by touching the "-" or "+" control.
• If you don't choose a heat setting within 1 minute, the
Induction hob will automatically switch off. You will need to
start again at step 1.
• You can modify the heat setting at any time during
cooking.
If the display flashes
This means that:
• you have not placed a pan on the correct cooking zone or,
• the pan you're using is not suitable for induction cooking or,
• the pan is too small or not properly centered on the cooking zone.
No heating takes place unless there is a suitable pan on the cooking zone.
The display will automatically turn off after 1 minute if no suitable pan is placed on it.

3.3.2 Finish cooking

Touching the heating zone selection control that you
wish to switch off
Turn the cooking zone off by scrolling down to "0" or
touching "-" and "+" control together. Make sure the
display shows "0".
Turn the whole cooktop off by touching the ON/OFF
control.
Beware of hot surfaces
H will show which cooking zone is hot to touch. It
will disappear when the surface has cooled down to
a safe temperature. It can also be used as an energy
saving function if you want to heat further pans, use
the hotplate that is still hot.

3.3.3 Using the Boost function

alternately with the heat setting
12
V.1