Installation; Preliminary Checks - entrematic Ditec PWR50H Manual Tecnico

6. Installation

The declared operating and performance features can only be guaranteed with the use of EN-
TREMATIC accessories and safety devices.
Unless otherwise specified, all measurements are expressed in mm.

6.1 Preliminary checks

Make sure the gate structure is sturdy and the hinges are lubricated and smooth.
If possible, fit an opening and closing stop. Otherwise, use the built-in mechanical stops and/or
the electric limit switches (optional) if available.
comply with the requisites of Standard EN12604.
The automation fastening point varies according to the space available and the gate to be
i
automated. The installer must therefore choose the best solution to ensure that the system
works correctly in each individual situation.
The installation measurements indicated in the table allow you to choose the values of [A] and [B] on
the basis of the required opening angle and in relation to the on-site spaces and overall dimensions.
Increasing measurement [A], you reduce the opening approach speed.
Reducing measurement [B], you increase the gate opening angle.
Measurements [A] and [B] must, however, be compatible with the effective piston stroke.
Tab. 6.1
A B
200 190
200 200
100 220
130 210
170 220
200 190
150 220
130 290
D
C S
20 170
50 150
50 170
70 140
100 120
100 90
150 70
220 70
The mechanical construction elements must
A
P
min 60 con apertura a 90° min 60 with 90° opening
D E
120°
110°
90°
95°
120
95°
100°
95°
90°
29
L P min
220
220
120
150
910
190
220
170
150