Factory Reset - Sonoff TX US Manual De Instrucciones

Factory Reset

Long press any button you desired to pair for about 5s until the Wi-Fi LED
indicator changes in a cycle of two short and one long flash and release, then
the reset is successful. The device enters quick pairing mode (Touch).
Please reset the switch to factory defaults if you want to use other Wi-Fi networks, then
reconnect the network.
RF Remote Controller Pairing
The switch supports the remote controller with 433.92MHz frequency brand to
turn on/off, and each channel can learn it independently, which is local short-
range wireless control not Wi-Fi control.
Pairing Method:
Long press the touch button you want to pair until you hear a "beep" sound and
release, then press the corresponding button on the RF remote controller, and
you will hear a "beep" sound again after successful pairing. Other buttons can
be paired through this method.
Clearing Method:
Long press the touch button you want to clear until you hear two "beep" sounds
and release, then press the corresponding button on the RF remote controller,
and you will hear a "beep" sound again after successful clearing. Other buttons
can be cleared through this method.
SONOFF TECHNOLOGIES CO., LTD.
3
English