Connect The Compressed Air Line - Abicor Binzel TSi Instructivo De Servicio

6 Putting into operation

6.3 Connect the compressed air line

Carry out each step in accordance with the figures below:
A
C
12
11
10
1 Mounting screw x 2
2 Hood
3 Throttle volume control
4 2 directional valves
5 Suction valve (Venturi Valve)
Fig. 6 Connect the compressed air line
NOTICE
• Note the maximum operating pressure of 6 bar (0.6 MPa).
• Check all of the connections for proper installation and damage.
• Make sure that the suction line (11) is mounted with the non-return valve (10). The end of the hose of the suction line
(11) should at least reach to the bottle base.
• Make sure that the return line (12) is mounted in the empty release agent bottle (8).
1 Connect the compressed air connector to the connecting pipe (6).
2 Position the suction line (11) with the non-return valve (10) in the full release agent bottle (9).
3 Position the return line (12) in the empty release bottle agent (8).
EN - 10
1
B
9 8
6 Connecting pipe
Outer Ø = 8 mm; L = 1000 mm
7 Connecting hose
Outer Ø = 8 mm
8 Release agent bottle, empty
2
3
4
5
7 6
9 Release agent bottle, full
10 Non-return valve
11 Suction line
Outer Ø = 6 mm;
L = 1000 mm
TSi injection unit
12 Return line
Outer- Ø = 8 mm;
L = 1000 mm
BAL.0468.0 • 2019-11-04