Ec Declaration Of Conformity - Proxxon SP/E Manual De Instrucciones

Never run the grinding wheels without the protection
hoods.
8. Reattach the lateral covers and fasten them securely.
Danger !
Danger of injury !
efore the first use run the grinding wheel for approx. 5
minutes without any load at highest speed. During this time
leave the danger area.
Maintenance
ttention !
Spare parts must only be installed by a specialist.
Proxxon does not assume liability for damage caused by
the unprofessional replacement of spare parts.
ttention !
Before any service or cleaning work pull the mains plug
out.
fter use
1. Pull the drawer 6 ( Fig. 1 ) out to side and empty it.
2. Clean the unit with a brush or a soft cloth from all
grinding dust. Make sure that all ventilation slots are free
and unrestricted.
Cleaning
Caution!
lways disconnect the mains plug before doing any
cleaning, setting, maintenance or repair works!
Note: The machine is mostly maintenance free. For a
long service life, the device should be cleaned after
every use with a soft cloth, hand brush or a soft brush.
Even a vacuum cleaner can be recommended.
External cleaning of the housing can be carried out using a
soft, possibly moist cloth. While doing so, a mild detergent
or other suitable cleansing agent can be used. Do not use
solvents or cleansing agents containing alcohol
(e.g. benzene, cleaning alcohol, etc.) as these can corrode
the plastic housings.
Disposal
Please do not dispose of the device in domestic waste!
The device contains valuable substances that can be
recycled. If you have any questions about this, please
contact your local waste management enterprise or
other corresponding municipal facilities.
EC-Declaration of conformity
Name and address:
PROXXON S. .
6-10, Härebierg
L-6868 Wecker
Product designation: SP-E
rticle No.: 28030
In sole responsibility, we declare that this product
conforms to the following directives and normative
documents:
EU EMC Directive 2004/108/EC
DIN EN 55014-1 / 02.2010
DIN EN 55014-2 / 06.2009
DIN EN 61000-3-2 / 03.2010
DIN EN 61000-3-3 / 06.2009
EU Machinery Directive 2006/42/EC
DIN EN 61029-1 / 01.2010
Date: 13.05.11
Dipl.-Ing. Jörg Wagner
PROXXON S. .
Machine Safety Department
The CE document authorized agent is identical with the
signatory.
- 9 -