Using Your Speaker System; Controlling The System; Controlling The Volume - Bose COMPANION 3 Series II Guía De Usario

English Español

Controlling the system

Figure 8
Switches and settings
Français
To begin using your Companion
1. Be sure your computer or other sound source is turned on.
2. If you have not yet done so, also turn on the power switch on the rear of the Acousti-
mass ® module.
If the LED on the control pod is yellow, touch the top of the control pod to active the system.
The light then turns green.
Power
switch

Controlling the volume

To adjust the sound level using your speaker system controls:
• For volume – Rotate the outer band on the control pod clockwise to increase or counter-
clockwise to decrease the volume (Figure 8).
• For mute – Gently press the mute/standby touch control on the pod. To unmute, press
again.
The control pod LED light turns yellow when the system is muted (or in standby mode), and
green when it is active.
To use the sound source volume control instead of the control pod:
• Rotate the outer band on the control pod clockwise until it approaches maximum volume.
• Use the volume control on your computer or other sound source to adjust the level as you
listen.
Note: Setting a source volume control to the highest level may activate the speaker system's
internal protection circuity and reduce speaker volume.
!"#$%&'()*%)+#,-*./01&2 2 34!5
U
SING YOUR SPEAKER SYSTEM
®
3 speaker system (Figure 8):
Bass compensation
Mute/activate
Standby/active
touch control
LED
Volume
control
Headphone
Sound source
jack
jack
11