Cleaning And Maintenance; Switching Off The Appliance - Ghibli & Wirbel POWER STEAM 5.3 MI Uso Y Mantenimiento

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
- Repeat the operations described above to
carry out the cleaning of another part of
the surface of the floor.
Cleaning carpets and rugs
NOTE:
If the carpets or rugs are very dirty it is rec-
ommended that you vaccum them with your
normal vacuum cleaner before using this ap-
pliance; in the presence of very old stains is
recommended to spray a specific detergent
on the stain before acting with steam.
- Assemble the rigid extensions (2 Fig. 1),
the squeegee (3 Fig. 1) with the relative
frame for carpet (optional).
- Place the nozzle on the ground and begin
to clean only supplying steam via the le-
ver (35 Fig. 11).
- Clean about 1-2 m
start the vacuum by pressing the switch
(34 Fig. 11) and remove the dirt as it de-
livers steam.
- Tilt the nozzle 45° backwards going for-
ward; tilt the squeegee forward working
backwards.
- Repeat the operations described above to
carry out the cleaning of another part of
the surface of the floor.

Switching off the appliance

NOTE:
Before switching off the device clean the
suction tube by vacuuming 2-3 liters of clean
water.
- Press the switches (32 and 33 Fig.11) to
"0" to switch off the appliance; the lamps
on the switches will go out.
- Remove the plug (42 Fig.15) from the
electrical socket.
- Wind up the cable (41 Fig.16) and hook it
onto its housing (43 Fig.16).
of carpet and then
2
ENGLISH - 7
CLEANING AND
MAINTENANCE
DANGER:
Before carrying out any maintenance
operation, remove the power plug from
the wall outlet and wait until the water in
the boiler cools.
Daily cleaning
Emptying the recovery tank
- Remove the hose (13 Fig. 3) as described
in the relevant paragraph.
- Disconnect the power plug (32a Fig. 17)
which is supplying the powehead.
- Lift up the levers (37 Fig. 12) and remove
the cover (38 Fig. 13) complete with mo-
tor.
- Release the levers (44 Fig. 18) and re-
move the tank (45 Fig. 19).
- Place yourself over a floor drain and
empty the liquid in the recovery tank (45
Fig. 19).
- Clean the inside of the tank with run-
ning water, if necessary, use degreasing
agents and disinfectants according to the
dirt inside; dry the tank before reassem-
bling everything in the reverse order of
removal.
Cleaning the appliance body
- Clean the unit body with a cloth damp-
ened with water or a mild detergent;
DANGER:
Do not wash the appliance using jets of
water.