Getting Started - Unpacking; Items Supplied - Evolution EVOMAG42 Instrucciones Originales

• Always prepare the material surface before
attaching the machine. The material
surface must be clean, flat and free
from rust, protective coatings, grease or
other debris such as chips or swarf from
previously drilled holes.
• Always check the surface of the magnetic
base ensuring that it is not damaged and
is clear of debris such as chippings or swarf
from previously drilled holes.
• Never use this machine on a structure
where arc welding is taking place. Damage
to the machine will result as the welder will
ground through the power tools ground or
earth cable.
6) DURING CUTTING OPERATIONS
WARNING: The swarf and the slug
produced will be hot and sharp.
• When using annular cutters ensure that the
slug ejected at the end of the cut will not
endanger anyone in the vicinity.
• If working at height some form of collection
device for the ejected slug may be necessary.
• Care should be taken with the ejected
slug, this will be both hot and sharp, gloves
should be worn when handling the slug.
• This power tool can be used on a vertical
surface or upside down provided there is
sufficient magnetic adhesion, extra care
should be taken when drilling vertically or
inverted . When using the machine vertically
or inverted it is possible hot and sharp swarf
or chips may fall. Always wear appropriate
personal protective equipment.
7) SAFETY STRAP OR SAFETY CHAIN
WARNING: The electromagnet base on this
power tool can deactivate if the power supply is
interrupted or suffers an electrical malfunction.
• To prevent possible operator injury, the safety
strap or chain supplied should be used at all
times to provide extra security in the event of
supply failure or electrical malfunction.
Note: When drilling some very large flat,
horizontal plates, the fitting of the safety
strap or chain may be impossible. Consult the
responsible person for guidance.
www.evolutionpowertools.com
• The safety strap or chain should be
attached to the fixing points provided and
checked for security before commencing
any and every drilling operation.

GETTING STARTED - UNPACKING

Caution: This packaging contains sharp objects.
Take care when unpacking. This machine
could require two persons to lift, assemble and
move. Remove the machine, together with the
accessories supplied from the packaging. Check
carefully to ensure that the machine is in good
condition and account for all the accessories
listed in this manual. Also make sure that all the
accessories are complete. If any parts are found
to be missing, the machine and its accessories
should be returned together in their original
packaging to the retailer. Do not throw the
packaging away; keep it safe throughout the
guarantee period. Dispose of the packaging in
an environmentally responsible manner. Recycle
if possible. Do not let children play with empty
plastic bags due to the risk of suffocation.

ITEMS SUPPLIED

DESCRIPTION EVOMAG42
Instruction Manual
Coolant System
Safety Guard & Fixings
Safety Strap
Feed Handles
Hex Keys
Chuck with Chuck Key
Carry Case
10
S28MAG
(x3) (x3)
(x4) (x2)