Installing An Annular Cutter - Evolution EVOMAG42 Instrucciones Originales

NOTE: S28MAG is fitted with a 10 Amp 230v (5 x 20mm) Surge
Fuse. This is located in a fuse holder found in the machines switch
panel. (Fig. 5) If the machine fails to operate, check the fuse. If it
has 'blown' have the cause investigated by a competent technician.
Replace it with an identical type when satisfied that the machine
is fault free.
• Check that the machine is firmly attached to the Mild Steel plate.
• Operate the machines On/Off rocker switch (Fig. 6) to switch
'On' or to switch 'Off' the machines motor.
• Allow the motor to run for a few seconds to check for any
unusual noise or vibration.
WARNING: Do not use the machine if any vibration or unusual
noises are evident or if the magnetic adhesion is questionable.
Have the machine serviced and checked by a qualified technician,
or if under warranty refer to the warrantee agreement.
• When all testing has been completed, turn the machine 'off.'
INSTALLING AN ANNULAR CUTTER - All Evolution
Machines
Select a suitable cutter for the required task. Check that the cutter
is sharp and is not damaged in any way. Damaged or 'dull' cutters
should not be used.
WARNING: Annular cutters are very sharp. It is recommended
that the operator wears protective gloves whilst handling a cutter
during installation or removal.
• Insert the pilot pin into the cutter ensuring that it slides through
the bore in the cutter smoothly. (Fig.7)
• Raise the machines Cutting Head (the Motor/Gearbox assembly)
to its highest position.
• Check that the cutter securing grub screws located in the end of
the spindle are not protruding into the spindle bore.
(EVOMAG42 - Fig.8. ) (S28MAG - Fig.9)
• Align the two 'flats' machined on the cutters shaft with the grub
screws in the spindle.
• Insert the cutter shaft into the bore of the spindle.
• Start to tighten one of the grub screws and at the same time
slightly rotate the cutter backwards and forwards until the
grub screw is fully tightened. This will ensure that the grub
screw is located squarely onto the flat, preventing the cutter
from becoming loose.
• Tighten the remaining grub screw.
www.evolutionpowertools.com
Fig. 4
Fig. 5
Fig. 6
Fig. 7
14