Mitsubishi Electric PAC-WHS01HC-E Manual De Instalación página 3

(Improper handling may have consequences, including injury or damage to house.)
■ To prevent damage from static electricity, touch a
nearby metal body to discharge static electricity from
yourself before touching the Equipment Controller.
Static electricity from the human body may damage the
Equipment Controller.
■ Do not install the Equipment Controller in places with
direct sunlight or where the ambient temperature is
104ºF (40ºC) or more or is 32ºF (0ºC) or less.
Direct sunlight and high or low temperature environments
may cause the Equipment Controller to deform or breakdown.
■ Turn off power supply of Equipment Controller and
connected equipment when performing construction or
wiring work.
Failure to turn off the power supply to the connected
equipment may lead to malfunction or breakdown of the
Equipment Controller or connected equipment.
■ Do not install the Equipment Controller where
combustible gases may leak, be produced, flow, or
accumulate.
If combustible gas accumulates around the Equipment
Controller, it may cause fire or explosion.
■ When installing the Equipment Controller in a hospital
or in a building where communications equipment are
installed, you may need to take measures to avoid noise
and electronic interference.
Inverters, home appliances, high-frequency medical
equipment, and radio communications equipment can cause
the Equipment Controller to malfunction or to breakdown. At
the same time, the noise and electronic interference from
the Equipment Controller may disturb the proper operation of
medical equipment, and communications equipment.
■ Visit kumocloud.com/resources for additional information
about controlling the PAC-WHS01HC-E from your web
browser or smart phone.
Caution
■ Do not install the Equipment Controller in a place with
large amounts of steam, such as bathroom.
Avoid places where water is splashed or where condensation
forms on walls. Installing in such places can cause electric
shock or breakdown.
■ Do not use the Equipment Controller in an unusual
environments.
If the Equipment Controller is installed or exposed to steam,
volatile oil (including machine oil), corrosive gases, or briny
air, the internal parts can be damaged.
■ Connect to the indoor unit. (optional)
Please refer to the indoor units "service manual" for detailed
instructions for accessing the control interface connector
CN105 on the indoor unit control PCB.
■ Do not install the Equipment Controller in outdoor
location as it is designed for indoor installation only.
Otherwise, electric shock or breakdown may be caused by
water drop, wind, or dust.
■ Do not wash the Equipment Controller.
There may be a risk to get an electric shock.
■ Before starting operation, check that all protective parts
are correctly installed.
Make sure not to get injured by touching high voltage parts.
■ Do not touch any switch with wet hands.
There may be a risk to get an electric shock.
Note
■ The PAC-WHS01HC-E should not be installed and
connected to any Mitsubishi Electric system which is to
provide cooling or heating to critical applications.
EN-2