Cabinets; Step 9, Adjust Door Swing; Step 10, Install Grille Panel - GE Profile PSB42LGRWV Instrucciones De Instalación

8 SECURE REFRIGERATOR
TO CABINETS
Whenever possible, perform this step for anti-tip
security.
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Drive a screw through the trim and into the adjacent
cabinet, using the holes provided.
• Follow the same procedure on the opposite side.
Raise Grille Panel
to Stop Position
Drive Screws
Through Case Trim Into
Adjacent Cabinets
9 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening.
SKIP THIS STEP IF DOOR OPENING IS SATISFACTORY
FOR YOUR INSTALLATION SITUATION.
• Open the door to view the bottom hinge. Note the
door stop pin location. The pin is factory installed in
the 130° position.
• Partially close the door. From above, use a flathead
screwdriver to unscrew the door stop pin and
reinstall into the 90° position.
Interior
90°
130°
Hinge
Installation Instructions
Door
10 INSTALL GRILLE PANEL
• Raise the grille panel to stop position.
Raise
Grille
Panel
• Remove 4 screws on bottom trim; retain all screws.
• Remove bottom trim.
• Slide panel over the metal backer panel and under
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
17