NEO ION 610B Manual De Usuario página 11

5. DMX CONNECTION AND DMX PROTOCOL
DMX addressing
The device is controlled by universal DMX 512 pro-
tocol, DMX address is the start channel used to re-
ceive instructions from the external controller. For
independent control, each fixture must be assigned
its unique address control channels. For example,
this device has four channel modes: 18/21/17/20,
if we set the mode at standard 21 channels mode,
and there are several models need to be inde-
pendently controlled, we just simply address first
fixture at 1, and second fixture at 39, third one at
60, etc. If the devices have the same address, they
will behave synchronically.
DMX addressing is limited, don't set the address so
high that without enough control channels for the
fixtures. Display is flashing when no DMX signal is
received.
Connection: us DMX cable with 3-pin XLR-plugs
to connect the controller with the fixture or one
fixture with another.
This device is equipped with 3-pins DMX in and
out sockets only.
Pin 1 = GND | Pin 2 = Signal (-) | Pin 3 = Signal (+)
The termination is prepared by soldering a 120Ω
resistor between pins 2 and 3.
P. 11
English version
- Neo ION 610B RGBW