Tabla de contenido
Publicidad
Cleaning and care
• Keep the vent slots clean and without obstructions to
guarantee adequate motor cooling.
• Inspect every now and then all the mounting screws and
verify they are correctly fastened. If a screw is loose tighten
immediately.
Service
• Service for the tools shall only be carried out in a
Authorized Service Center.
• Service and maintenance carried out by non-qualified
people may be dangerous and could cause personal injury.
It also makes the Warranty void.
8
ENGLISH
Maintenance
Lubrication
• We recommend taking the tool to a
Authorized Service Center to lubricate the drive wheel
every time replacing carbon brushes is needed.
Carbon brush replacement
• Carbons should be checked periodically. When worn
take the tool to a
center to have them replaced.
• After replacement ask to see if the new carbons can
move freely inside the carbon housing and to run the
motor 5 minutes to even contact between carbons and
commuter.
• Use only original
specifically designed with the hardness and resistance
adequate for each type of motor. Carbons that are out of
specification could damage the motor.
• Both carbons should be changed simultaneously.
Authorized Service
spare carbons
Publicidad
Tabla de contenido
