Start Up; Speed Control; Rotation Direction - Truper TAL-3/8N2 Manual De Instrucciones

Start up

Bit fitting
• Put the bit into the chuck until it stops. Fasten with the
chuck wrench and tighten alternatively the chuck into
each of the orifices.
Start up and operation control
• Intermittent operation:
Connect the plug into the power outlet.
Press the switch (A) to start the drill.
To stop, just release the switch.
• Continuous operation:
Connect the plug into the power outlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.

Speed control

• The tool can operate in different speeds. These can be selected adjusting the
speed control (C). Turn the speed control in a clockwise direction to increase the
Drill speed. Turn in a counterclockwise direction to decrease speed.

Rotation direction

• To get the bit to rotate forward and drill, move the rotation selector lever (D)
towards the arrow pointing the chuck.
• To get the bit go reverse and use the tool as a drill, move the rotation selector lever
towards the arrow pointing the drill handle.
• Set the drill in a regular operation position. The rotation direction lever shall be
placed in the right side of the trigger (seen from the back) to operate the tool as a
drill or as shown in the figure.
Bit
D
Chuck
Chuck
wrench
D
C
A
Rotation selector lever
in the drilling position
A
ENGLISH
B
7