Maintenance - Truper TALE-1/2N Manual De Instrucciones

Chuck Change
• Remove the auxiliary handle and open wide the chuck
jaws.
• Using a screwdriver remove the left-threaded safety
screw with a clockwise movement.
• Fit the long side of an "L" (not included) Allen key in a
vise and insert the short side of the "L" (not included) Allen
key to the chuck. Close the jaws.
• Move the rotation selector lever into the reverse position
(page 7 Rotation Direction) and activate the drill holding it
firmly. The chuck will be released with the turn.
• Set the new chuck turning it into the drill thread until it
stops.
• Open the jaws fully and thread the screw
counter-clockwise. Tighten with a screwdriver.
Carbon Brush Replacement
• Carbon brushes shall be checked periodically.
• If one or both carbons are worn go to a
Authorized Service Center to replace
both carbon brushes. When replaced, ask the technician to
inspect if the new carbon brushes move freely in the
carbon brush housing. Ask to turn on the tool during five
minutes to make the contact in the carbon brushes and the
commuter even.
• Use only original
brushes, designed specifically with the right strength and
electric resistance for each type of motor. Carbon brushes
with different specifications may damage the motor.
• When replacing carbon brushes, always change both.
Lubrication
• We recommend lubricating the tool transmission every
carbon brush change in a
Service Center.
8
ENGLISH
spare carbon
Authorized

Maintenance

Phillips
Screwdriver
Vise
Cleaning and Care
• To guarantee adequate motor cooling, always keep slots
clean and free of obstructions.
• Regularly inspect all the mounting screws. Double-check
they are properly tight. If any screw is loose tight
immediately.
Service
• Service should only be carried out in a
Authorized Service Center. Service and maintenance
performed by non-qualified people may be dangerous and
can lead to personal injuries. It also makes the product
Warranty void.
C