10 General Settings; Printouts; Display; Display Brightness - intellic EFAS Manual De Instrucciones

Over speeding
Technical data
Speed profile
Engine speed profile
D1/D2 status changes
Confirm your choice with OK, then use the control keys to select the desired date, and confirm with OK.
The stored data is printed. Pull the paper off (transversely/upwards) in order to get a clean tear.
If two driver cards or a driver card and a workshop card are inserted, you have to specify from which card
the data has to be printed.
Use key to cancel printing at any time.
Data cannot be printed when driving. Any printout is cancelled when the vehicle starts moving. Leave the
ignition on when printing. The printout is halted when the ignition is turned off. If the ignition is switched
off for more than 30 seconds, the print job is cancelled.
Printing is interrupted when the printer runs out of paper, the following
message appears:
The end of printing is marked. When you insert a new reel of paper, printing continues automatically and
is marked as a continuation of the interrupted printout.
For inserting a new reel of paper, please see the accompanying „EFAS Quickstart".

10 General Settings

10.1

Printouts

According to EU regulations, the times specified on the printout and in the print preview are output in
UTC time. For easier inspection, the times can also be output in local time by using the setting "Local
Time".
Select OK
1.
Printout
The current setting is displayed.
2. Use control keys
10.2

Display

10.2.1 Language
EFAS supports a multitude of languages. The language which is used for the digital tachograph display
depends on the tachograph card which is inserted in the left-hand card slot. The language is automati-
cally set upon card insertion or withdrawal. However, you can select the language manually.
Select OK
1.
Settings
The current language is displayed.
2. Use control keys
The dialog for manually selecting the display language is also invoked by pressing
onds.
10.2.2

Display Brightness

If your EFAS is not connected to the central brightness control for the dashboard lighting of your vehicle,
the display brightness for day and night can be set via the menu. The day mode is stored when the
vehicle lights are off. The night mode is stored when the vehicle lights are on.
Local Time.
to select the required setting. Press OK.
and
Display Language.
to select the required language. Press OK.
and
for at least 5 sec-
16