Determining The Arm's Travel; Installing The Guide - FAAC Night ONE Day Manual De Instrucciones

10.2 Determining the arm's travel

Mark the position on the shutter of the arm spacer:
1) Shutter open
2) Shutter closed

10.3 Installing the guide

Fit the bush in the guide and position it on the open shutter.
1) Centre the guide on the shutter and level it.
2) Fit the plugs and secure with 5x35 screws.
3) After starting up (see chapter 11), electrically command the shutters to open and allow the motor to run
for a few seconds with the shutters open.
4) Make sure the shutters are well put in on the facade.
5) Firmly tighten the 12x20 screws of the arms (see ref.H fig.31 and 33).
1
Fig. 32

1. Shutter open
2. Shutter closed
2
Fig. 33
H