Initial Control Settings; Temperature Controls - JENN-AIR JCB2058GEB Guia Del Usuario

T
EMPERATURE
The controls are located at the top front of the refrigerator and freezer compartments. NOTE: The freezer control turns the
cooling system on. Neither section will cool if freezer control is set to off.
Refrigerator Control
I C
NITIAL ONTROL
S
ETTINGS
After plugging the refrigerator in, set the
controls.
➢ To adjust the controls, turn the
control knob to the left or right as
desired.
• Initially set the refrigerator control
on 4.
• Initially set the freezer control on 4.
• Let the refrigerator run at least 8-12
hours before adding food.
TEMPERATURE CONTROL GUIDE
Refrigerator too warm
Refrigerator too cold
Freezer too warm
Freezer too cold
Turn refrigerator OFF
NOTE: Turning freezer control to OFF stops cooling in both compartments. It does not shut off power
to the refrigerator.
C
ONTROLS
W C
ARM ABINET
S
URFACES
At times, the front of the refrigerator
cabinet may be warm to the touch. This
is a normal occurrence that helps
prevent moisture from condensing on
the cabinet. This condition will be more
noticeable when you first start the
refrigerator, during hot weather and after
excessive or lengthy door openings.
Turn the refrigerator control to next higher number.
Turn the refrigerator control to next lower number.
Turn the freezer control to next higher number.
Turn the freezer control to next lower number.
Turn the freezer control to OFF.
Freezer Control
A
C
➢ Twenty-four hours after adding food,
➢ Do not change either control more
➢ Allow 5-8 hours for temperatures to
➢ Changing either control will have
10
DJUSTING THE
ONTROLS
you may decide that one or both
compartments should be colder or
warmer. If so, adjust the control(s) as
indicated in the table below.
than one number at a time when
adjusting controls.
stabilize.
some effect on the temperature of
the other compartment.