How To Connect The Water Supply - JENN-AIR JCB2058GEB Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I
NSTALLATION
H
C
OW TO
ONNECT
W
S
THE
ATER
UPPLY
WARNING:
To reduce the risk of injury or
death, follow basic precautions,
including the following:
➢ Read all instructions before
installing device.
➢ DO NOT attempt installation if
instructions are not understood or
if they are beyond personal skill
level.
➢ Observe all local codes and
ordinances.
➢ DO NOT service device unless
specifically
recommended
owner's manual or published user-
repair instructions.
➢ Disconnect power to unit prior to
installing device.
CAUTION:
To avoid property damage or
possible injury, follow basic
precautions,
including
following:
➢ Consult a plumber to connect
copper tubing to household
plumbing to assure compliance
with local codes and ordinances.
➢ Confirm water pressure to water
valve is between 20 and 100
pounds per square inch. If water
filter is installed, water pressure to
water valve must be a minimum of
35 pounds per square inch.
➢ DO NOT use a self-piercing, or
saddle valve! Both reduce water
flow, become clogged with time,
and may cause leaks if repair is
attempted.
➢ Tighten nuts by hand to prevent
cross threading. Finish tightening
nuts with pliers and wrenches. Do
not overtighten.
➢ Wait 24 hours before placing unit
into final position to check and
correct any water leaks.
I
NSTRUCTIONS
MATERIALS NEEDED
1
" outer diameter flexible copper
4
tubing
➢ Shut-off valve (requires a
be drilled into water supply before
valve attachment)
➢ Adjustable wrench
1
" hex nut driver
4
Note:
Add 8' to tubing length needed to
reach water supply for creation of
service loop.
1. Create service loop with tubing using
care to avoid kinks in tubing.
in
2. Remove plastic cap from water valve
inlet port.
the
3. Place brass nut (A) and sleeve (B) on
copper tube end as illustrated.
3
"
16
,
.
CONT
4. Place end of copper tubing into water
1
" hole to
4
5. Slide brass nut over sleeve and screw
IMPORTANT: DO NOT overtighten.
Cross threading may occur.
6. Pull on tubing to confirm connection
7. Monitor water connection for 24
$
%
8
valve inlet port. Shape tubing slightly –
DO NOT KINK – so that tubing feeds
straight into inlet port.
nut into inlet port. Tighten nut with
wrench.
is secure. Connect tubing to frame
with water tubing clamp (C) and turn
on water supply. Check for leaks and
correct, if present.
&
hours. Correct leaks, if necessary.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Jcb2058gewJcb2059gesPjcb2059gs1

Tabla de contenido