Machine Components; Machine Setup; Installing Pad Driver / Pad / Brush - Tennant 2000 Manual Del Operador

OPERATION

MACHINE COMPONENTS

1
2
6
9
1. Power ON/OFF Twist Grips
2. Handle Height Adjustment Lever
3. Safety Lock Button
4. Speed Select Switch (Dual Speed Model)
5. Circuit Breaker Reset Button
6. Power Cord Hook
7. 15m (50 ft.) Power Cord
8. Motor Cover
9. Transport Wheels 102mm (4 in.)
10. Scrub Head Base
11. Bumper
6
3
4
5
7
8
10
11
Home Find... Go To..

MACHINE SETUP

Carefully check carton for signs of damage. Report
damages at once to carrier.

INSTALLING PAD DRIVER / PAD / BRUSH

FOR SAFETY: Before leaving or servicing
machine, unplug cord from wall outlet.
ATTENTION: If cleaning carpets, refer to the
"CLEANING CARPETS" section in this manual.
1. With the handle in the upright position carefully tilt
the machine backwards and rest the handle on the
floor.
2. Position pad on pad driver. If machine is equipped
with plastic centerlock, secure pad with lock.
NOTE: Consult your authorized distributor for pad and
brush recommendations. Use only manufacturer
supplied or approved pad drivers and brushes.
3. Position the pad driver/brush on the drive motor
hub and turn it counter-clockwise to engage
(Figure 1).
Pad Driver
OR
Brush
Pad
FIG. 1
4. Return machine to the upright position.
Tennant 2000/2010/2030/2040/2160/2170 (12- -05)