Additional Information - Truper ROEL-20N Manual Del Usaurio

Change the operation mode
• Press the locking button (E) and turn the operation mode selector (F) into one
of its 4 positions with regards to the job to be made.
• When set into the desired position release the locking button.
Never modify the position of the operation selector mode
WARNING
when the hammer drill motor is running.
Drill - screwdriver
No - impact Drill
Materials like steel, wood or plastic can be drilled with the
tool using a three-jaw chuck with SDS Plus adapter (NOT
INCLUDED).
• To set the three jaws chuck, proceed as with any other
SDS Plus accessory (see page 7, Bit / Accessory Assembly).
• Insert the bit into the three jaws chuck until it stops and
fasten with the chuck key tightening each of the orifices in
an alternate manner.
WARNING
Never use the three-jack chuck with the
operation mode selector set into the IMPACT (
) position.
Overload brake
The tool is built with an overload brake stopping the axis
force (and causing a clacking noise) is the accessory gets
stuck. In the event of this happening:
• Turn off the tool immediately.
• Remove the stuck accessory.
• Start the tool again.
8
ENGLISH
Impact drill
, ,

Additional information

• SDS Plus accessories need space to move inside the
chuck. This causes eccentricity when the tool has no load.
However, the accessory automatically gets centered during
the operation without affecting the drilling acuteness.
• The tool when new requires a 5-hour time working to
reach its maximum efficiency.
• When using the tool in the drilling or hammer drill mode
first, set the bit tip in the point where you are going to bore
and then, press the switch.
Start up
Chisel + adjustable angle
free mode, you can rotate
the chisel in any position.
F
E
Chiselled