Start Up; Speed Control; Rotation Direction - Truper ROEL-20N Manual Del Usaurio

Start up

Bit / Accessory assembly
• Before assembling clean and lightly lubricate the bit
and accessory.
• Push the blocking sleeve backwards while inserting the
bit / accessory.
• Release the blocking sleeve to put it back in its original position to
secure the bit / accessory. In case the blocking sleeve cannot be set back
into position repeat the previous step.
• To double-check the bit / accessory is properly fastened Trying to pulling
it out from the SDS Plus chuck. A bit / accessory properly installed cannot
be removed unless the blocking sleeve is pushed back at the same time.
WARNING Do not try to fix bits / accessories unless the tool is
disconnected.
Start up and operation control
• Intermittent operation:
Connect the plug into the power outlet.
Press the switch (A) to start the hammer drill.
To stop, just release the switch.
• Continuous operation:
Connect the plug into the power outlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.

Speed control

The tool can operate in different speeds. These can be selected adjusting the speed control (C) built in the switch. Turn the
speed control in a clockwise direction to increase the Hammer Drill speed and torque. Turn counterclockwise to lower
speed and torsion. Speed in increased depending upon the pressure applied on the switch (A).

Rotation direction

To get the bit to rotate forward and drill, move the rotation selector lever (D) towards
the arrow pointing the chuck. To get the bit go reverse and use the tool as a
screwdriver, move the rotation selector lever towards the arrow pointing the hammer
drill handle.
WARNING
Never use the tool in reverse when the impact-rotation selector is
in t he IMPACT ( ,
severely damaged.
WARNING
Never change the rotation selector lever when the hammer drill
motor is running.
, ) position, otherwise, the impact system will be
Bit with
SDS-PLUS shank
Locking
sleeve
B
C
A
Rotation selector lever
in the drilling position
D
A
ENGLISH
7