Bluetooth
®
The Bluetooth
device cannot be registered, or paired, with
®
the PSP
system.
®
There may be too much distance between the system and
the Bluetooth
device.
®
The Bluetooth
®
profiles that are supported by the system.
The maximum number of Bluetooth
paired is eight. Try deleting a registered device to pair a
new device.
A connection cannot be established between the Bluetooth
device and the PSP
®
Check that the Bluetooth
If it is not paired, go to
[Manage Bluetooth
pair the device.
Check that the Bluetooth
If the Bluetooth
with the system again.
There is no sound from the Bluetooth
Check that the Bluetooth
Try adjusting the volume on either the Bluetooth
the PSP
system.
®
Before requesting service
device may not be compatible with the
devices that can be
®
system.
device is paired with the system.
®
(Bluetooth
Device Settings)
®
Devices]
[Register New Device] to
®
device is turned on.
®
device has been reset, you must pair it
®
device.
®
device is not set in mute mode.
®
There is noise. The sound is not continuous.
If there are obstacles such as walls between the PSP
system and the Bluetooth
the devices and then connect the Bluetooth
If a device that causes radio interference such as a
microwave oven or an induction cook top or appliance is
nearby, communication with the system may not work
properly.
There is a delay in the audio.
Due to the characteristics of Bluetooth
may be a delay in the audio. If you feel the lag in the audio
is a problem, use wired headphones instead.
®
Other issues
The system or AC adaptor is warm.
During use, the system or AC adaptor may become warm.
This is not a malfunction.
When the communication function is being used, the
system may become warmer than during normal use. This
is not a malfunction.
The system is turned on, but does not operate.
Check that the system is not in hold mode. If it is, slide the
device or
®
POWER/HOLD switch up to clear hold mode.
®
device, change the location of
®
device again.
®
technology, there
®