Campbell Hausfeld PW2575 Manual De Instrucciones Y Lista De Piezas página 10

Operating Instructions and Parts Manual
Maintenance (Continued)
1. Turn the fuel valve to the OFF position to reduce the
possibility of fuel leakage.
2. Place a suitable container next to the engine to catch the
used oil.
3. Remove the oil filler cap/dipstick and drain the oil into the
container by tipping the engine toward the oil filler neck.
Please dispose of used motor oil in a manner that is
compatible with the environment. We suggest you take used
oil in a sealed container to your local recycling center or
service station for reclamation. Do not throw into the trash,
oust it on the ground, or pour it down a drain.
4. With the engine in a level position, fill to the upper limit
mark on the dipstick with the recommended oil.
5. Reinstall the oil filler cap/dipstick securely.
PUMP OIL CHANGING INSTRUCTIONS
Changing or refilling the oil in the pump requires removal of
the pump from the engine and should not be required unless
oil has leaked out due to worn or damaged oil seals in the
pump. If oil has leaked out of the pump, bring the pressure
washer to a certified Campbell Hausfeld service center for
repair.
TECHNICAL SERVICE
For information regarding the operation or repair of this
product, please call 1-800-330-0712.
MAINTENANCE SCHEDULE
MAINTENANCE
SCHEDULE
Daily
After first 5 hours of
operation
Every 25 hours of
operation
Every 50 hours of
operation
Each 100 hours of
operation or every 3
months
10
ACTION NEEDED
• Check water inlet screen and
filter.
• Check engine oil levels. Fill as
necessary.
• Check gasoline level. Fill as
necessary.
• Change engine break-in oil.
Use 10W-30 automotive
detergent oil. See your Honda
Owner's manual for specific
information.
• Change oil if operating under
heavy load or high ambient
temperature.
• Clean or replace paper air
cleaner cartridge. Tap gently to
remove dirt.
• Change oil.
• Replace spark plug.
• Replace paper air cleaner
cartridge.
• Change engine oil.
www.campbellhausfeld.com
Oil filler neck
Figure 16 - Oil drain and fill locations
TECHNICAL AND CONSUMER INFORMATION
HORIZONTAL ORIENTED PRESSURE WASHERS
Engine Oil Type
Engine Oil Capacity
Honda Engines
Engine Fuel Capacity
Honda Engines
Pump Oil Type
Wobble Pumps
Pump Oil Capacity
Vertical Wobble Pumps
Pump Detergent Suction
Water to detergent ratio
Water Supply Requirements
Minimum inlet pressure
Maximum inlet pressure
Maximum inlet temperature
Minimum inlet flow rate
Inlet garden hose size
Maximum inlet garden hose
length
REPLACEMENT PARTS INFORMATION
For information regarding where to order replacement parts,
call toll free 1-800-330-0712.
Please provide the following information:
• Model number
• Stamped code
• Part number and description
Address parts correspondence to:
Campbell Hausfeld
100 Production Drive
Harrison, Ohio 45030 U.S.A.
Oil filler
cap/dipstick
Upper limit
SAE 10W-30
SAE 30W (Above 60° F)
18.5 fl. oz.
0.29 gallons
80w90 gear oil
2.7 fl. oz.
8 to 1 (12% detergent)
20 psi
100 psi
100° F
5 gpm
5/8 inch I.D.
50 feet