Trigger Safety Latch; Surface Preparation - Campbell Hausfeld PW2575 Manual De Instrucciones Y Lista De Piezas

Assembly and Preoperation (Continued)

TRIGGER SAFETY LATCH

In the engaged
position, the trigger
safety latch prevents
the gun from being
triggered accidentally.
Push the latch fully up
to engage it (See Figure
10 and 11).
Always engage the
trigger safety latch
Figure 10 - Trigger locked
when the unit is not
in use.
Operation
SURFACE
PREPARATION
The following
cleaning procedure
will help you
organize your
cleaning task and
ensures that you
Figure 11 - Trigger unlocked
will achieve the best
results in the shortest
amount of time. Remember to use the spraying / cleaning
techniques mentioned in the following section.
Before starting a pressure washer cleaning job, prepare the
surface you intend to clean. Clear furniture from the area
and make sure that all windows and doors are closed tightly.
Also, protect all plants and trees near the cleaning area with
a drop cloth. A covering ensures that your plants won't be
sprayed by the detergents.
START UP
ALWAYS use this start up procedure to ensure that the unit is
started safely and properly.
If water has frozen in the pressure
washer, thaw the pressure washer in a
warm room before starting. DO NOT pour hot water on or into
the pump; internal parts will be damaged. Check for damage
before use.
1. Check engine oil levels. Add oil as necessary.
2. Check fuel level. Add unleaded gasoline (rated 86 octane
or higher) as required.
DO NOT refuel a hot engine. Refueling a hot
engine could cause a fi re. Use only fresh,
clean regular or unleaded gasoline. Close the fuel shutoff valve
during refueling.
3. Attach a garden hose to the inlet side of the pump and
connect it to the water supply. Use a hose with an internal
diameter (I.D.) of 5/8 in. (1.58 cm) and a length of 50 ft. (15
m) or less.
Some local plumbing codes require backfl ow
prevention when connecting to a fresh water
supply. Install a backfl ow preventer upstream from the pump if
necessary.
Engaged
Disengaged
www.campbellhausfeld.com
a. If inlet water pressure is over 100 psi, install a
regulating
water valve at
the garden hose
connection.
b. Do not exceed
100˚ F (38˚ C)
inlet water
temperature.
NOTE: The inlet water
supply must have a
minimum flow rate of 5
gpm (19 lpm).
4. Turn the water
supply ON.
Never run the unit dry. Be
sure the water
supply is completely
turned on before
operating the unit.
5. Trigger the gun
until water sprays
smoothly from the
tip indicating that
all air is purged from
the system. Lock the
trigger safety latch.
6. Open the fuel valve
by turning the knob
counterclockwise
until it stops. Close
the choke (if engine
is cold) by moving
the choke ring fully
to the right. Turn the
ignition switch to
"ON".
7. Start the engine.
Unlock the trigger
safety latch on the
gun (See Figure 11).
Grasp the starter
rope and brace one
foot on the chassis.
Point the gun in
a safe direction.
While squeezing
the trigger on the
gun, pull the starter
rope rapidly and
firmly (See Figure
12). Continue
holding the rope as
it returns. Repeat
these steps until the
engine starts.
MODEL: PW2575
Figure 12 - Start the engine
Figure 13 - Narrow high impact
stream
Figure 14 - 15° fan pattern
Figure 15 - Optimum angle to
cleaning surface
7