Campbell Hausfeld PW2575 Manual De Instrucciones Y Lista De Piezas página 13

General Troubleshooting Guide
Symptom
Oil leakage between the
engine and the pump
Fluctuating pressure
Pressure drops after period
of normal use
Pump noisy / pump runs
rough
Pressure washer will not
spray detergent
13
Possible Cause(s)
Worn oil seals and/or o-ring
1. Valve worn, dirty or stuck
2. Pump drawing in air
3. Tip clogged
1. Worn pump water seals
2. Nozzle worn
3. Valve worn, dirty or stuck
4. Unloader valve seat worn or dirty
5. Nozzle in low psi position
1. Pump drawing in air/low water
supply
2. Valves dirty or worn
3. Worn bearings
4. Water too hot
1. Not using soap tip
2. Clog, kink, or hole in detergent
suction hose
3. Hose length too long
4. Lance not functioning properly
5. Detergent too thick
www.campbellhausfeld.com
Corrective Action
See service center or call customer service for
replacement kits.
1. Check and replace
2. Ensure hoses and fittings are tight. Purge air
from garden hose
3. Check or replace
1. Check and replace
2. Check and replace
3. Check, clean or replace
4. Check, clean or replace
5. Pull back nozzle to high pressure position
1. Ensure fittings are tight. Increase water pressure
2. Check, clean or replace
3. Check and replace
4. Reduce temperature below 100° F
1. Install 65 degree (black) soap tip
2. If clean, unkink or replace hose.
3. Use only hose length provided with initial
purchase of pressure washer. Detergent suction
will not function if more than one section of
hose is attached to unit.
4. Remove lance from gun. If detergent is
dispensed through gun, the lance must be
replaced. If no detergent is dispensed through
gun, remove
1 inch tapered detergent barb from pump. Clean
the barb, and make sure that ball and spring are
properly aligned with tapered portion of the
spring facing the ball. The ball should be on top
of the spring.
5. Should be consistancy of water.
MODEL: PW2575
13