Quick Start - Single System Setup - Samson AirLine 88 Manual Del Usario

Quick Start - Single System Setup

When the transmission is complete, the CR88 will
receive RF signal and the tone key from the transmitter.
The READY indicator will light on the front panel of the
CR88 receiver.
Turn on your connected amplifier or mixer, but keep
the volume all the way down. Set the Volume knob
on the CR88 fully clockwise (to its "10" setting).
This is unity gain.
Play your instrument at normal performance level.
Slowly raise the volume of your amplifier or mixer
until the desired level is reached.
If you find the system has noticeable dropouts, reduced overall working range, or
unexpected noise bursts, change the operating channel of the system using the steps
o turn on 9. Press and hold SELECT button to IR set 10. Adjust Volume control
above.
Multiple System Setup
When using multiple systems, each system must be set to a different operating channel.
Transmitter and receiver pairs must be on the same channel plan in order to work
together.
When setting an additional transmitter, make sure to move all other transmitters away
from the receiver to ensure that the transmitter is not accidentally reset.
pack transmitter 9. Press and hold Select button to IR set
AirLine 88 Guitar Wireless System 7