Tabla de contenido
Publicidad
Step 10
BLACK 9/16" LARGE HEAD SCREW
(16 used for the BRACKETS)
1
D2
D262
å
Pull a set of DRAWER FRONT BRACKETS (9G) apart and slide
them into the grooves in the DRAWER SIDES (D257 and D262). You
may need to gently tap them in with a hammer.
å
NOTE: The DRAWER FRONT BRACKETS are marked "RH" and "LH"
for easy identifi cation.
å
Fasten the DRAWER FRONT (D2) to the DRAWER FRONT
BRACKETS (9G). Use four BLACK 9/16" LARGE HEAD SCREWS (1S).
3
M64
Surface with
D2
HIDDEN CAM
Fasten the DRAWER BRACE (M64) to the DRAWER
å
FRONT (D2). Tighten one HIDDEN CAM.
Page 14
Push down
1S
9G
(4 sets used)
D257
Maximum
Arrow
210 degrees
Minimum
190 degrees
Hidden part using
recycled material.
Color may vary.
VIEW THE T-SLOT BOX VIDEO
2
U n fi
D262
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide a DRAWER BOTTOM (D981) into the grooves
å
in the DRAWER SIDES (D257 and D262) and
DRAWER FRONT (D2).
4
D262
M64
Fasten the DRAWER BACK (D175) to the DRAWER
å
SIDES (D257 and D262) and DRAWER BRACE (M64).
Use fi ve BLACK 1-9/16" FLAT HEAD SCREWS (30S).
å
Repeat this step for the other DRAWERS.
423107
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
D981
n i s h
e d
s u r
f a c
e
D2
D257
Start each screw a few turns before
completely tightening any of them.
30S
BLACK 1-9/16" FLAT HEAD SCREW
(20 used in this step)
D175
Be sure the
DRAWER
BOTTOM
inserts into
D257
the DRAWER
BACK groove.
www.sauder.com/services
Publicidad
Tabla de contenido
