Troubleshooting Guide - Aircare EA12 SERIE Guía De Uso Y Cuidado

TROUBLESHOOTING GUIDE

Trouble
Digital display not
illuminated.
Fan not operating (digital
display is illuminated).
Fan running continuously.
Poor evaporation of water.
Water leaking from unit
Display flashes "20"
Display flashes "—"
"CF" message does not
appear even when wick is
dirty or humidifier per-
formance is clearly reduced.
Display blinks or fan moves
slightly when humidifier is
plugged in.
Alternating "F" and room
humidity displayed.
Alternating "CF" and room
humidity displayed.
Control panel does not
respond to input.
Display shows CL
Probable Cause
• No Power.
• Power button has not been
depressed.
• ROOM humidity level is not
3% or more below SET
humidity level.
• SET humidity level is 65%.
• ROOM humidity level has
not reached 1% or more
above SET humidity level.
• Plastic float is obstructed or
damaged.
• CF (Check Filter) message
flashing.
• Build up of minerals on
wick.
Unit has been overfilled
ROOM Humidity is lower than
20%.
• Unit initiating.
• Room humidity is over 90%.
• Loss of power or a power
failure has caused the CF
message to prematurely
reset.
• Normal
• Reservoir is empty.
• Fill float is damaged
• Wick may be dirty.
• Control lock feature has been
turned on to prevent
changes in settings.
10
Remedy
• Check 120 volt power source.
• Press power button once to turn
on.
• Raise SET humidity level if
desired.
• A SET humidity percentage of
65% operates fan continuously.
Adjust SET level between 25%-0%.
• Continue to run until desired
humidity level is achieved. This
may take up to 48 hours initially.
• Remove obstruction or replace
float.
• Change to a fresh new filter.
NOTE: Local water varies from
area to area and under certain
conditions mineral will build up
more rapidly in the filter.
Fill reservoir only to Max Fill mark.
• Will read actual humidity when
level comes up to 25%.
• Room humidity will display after
initiation is complete.
• Will remain until humidity drops
below 90%.
• Replace wick.
• No action required.
• Fill humidifier with water.
• Fill float will have to be replaced
• Replace wick, if needed
• Unplug unit for 30 seconds
and plug back in to clear display.
• Press Humidity and Speed
buttons at same time for 5
seconds to deactivate feature.