Epson EB-W16SK Guía De Inicio página 8

Setting Up
Stacking and
installing the
commander and the
receiver
Use the stacker mounts
to create a stacked
configuration (one
projector on top of the
other).
Secure the polarizers for the
commander and the receiver
with the screws supplied.
8 8 8 8 8
A
Warning
When assembling a
stacked configuration,
make sure you follow
these steps. If the steps are
projectors, stacker mounts,
not followed correctly, the
and polarizers. Make sure
product could fall, or your
the numbers match when
fingers could get caught,
assembling.
which could cause an
injury.
B Attach the feet (when C
setting up on a desk).
Attach the front foot (one) and Carefully remove the protective
the rear feet (two) to the base tape from the stack angle
of the receiver. Turn the feet to adjustment screws, and then
extend and retract to adjust the remove the screws. (on the left
horizontal tilt. and right)
Attach the polarizers to the commander and the receiver.
There is a number on
the base of the
Commander
Turn over the commander and the receiver, and then attach the
polarizers.
Press until they click into place.
Receiver
Stack the commander and the receiver.
Loosen the screws for the commander's stacker mount connector. (on the
left and right)