Function And Range Selection; Transformer Jaws; Data Hold; Input Jacks - koban KPA 03 Manual Del Usuario

KPA 03
Digital clamp multimeter
Function and Range
selector
A rotary switch is used to
measurement functions and ranges.
When the switch is set to OFF
position, the meter does not operate.

Transformer Jaws

Pick up the AC current flowing
through the conductor.
Press the TRIGGER to open the
transformer jaws.
When the finger press on the
TRIGGER is released, the jaws will
close again.

Data Hold

Depress HOLD Button Switch to
toggle in and out of the
Data Hold mode. Releasing Data
Hold mode again press
the button.
Instructions manual | 16

Input Jacks

This meter has three input jacks that
are protected against overload to the
limits shown.
During use connect the black test
lead to COM jack and connect red
test lead to V jack. The red test lead
is depended on function selected.
The EXT jack is used for accept
insulation tester unit EXT banana
Plugs, when measurement insulation
resistance.

Operating Instruction

Measuring Current

1. Set the rotary switch at desired
A~ range position. Press the
trigger to open the transformer
jaws and clamp onto one
conductor only (Fig1). The
transformer jaws pick up the
AC current flowing through the
conductor.
2. When only the figure "1"
displayed, it indicates overrange
situation and the higher range
have to be selected.
www.grupotemper.com