Abicor Binzel AUT-WIG 20G Instructivo De Servicio página 34

11 Dismounting
11 Dismounting
Dismounting may only be carried out by specialized personnel. Please make sure that the
shutdown procedures are strictly observed, before the dismounting work begins. Ensure this also
for the components integrated into the welding system.
DANGER
Risk of injury due to unexpected start-up
The following instructions must be adhered to for the entire duration of maintenance,
servicing, mounting, dismounting and repair work:
• Switch off the power source.
• Close the gas supply.
• Close off the compressed air supply.
• Close off the coolant supply.
• Disconnect all electrical connections.
• Switch off the entire welding system.
NOTICE
• Consult the documentation for the welding components.
• Observe the information provided in the following section:
 8 Putting out of operation on page EN-13.
1 Disconnect the TIG welding torches from the power supply.
EN - 16
AUT-WIG
BAL.0166 • 2019-01-03