Basic Cleaning; Troubleshooting - Abicor Binzel AUT-WIG 20G Instructivo De Servicio

AUT-WIG
• Continuous adjustment of the angle.

9.2 Basic cleaning

We recommend basic cleaning once a week. The type and frequency of cleaning shall be
determined and established by the system operator of the welding system.

10 Troubleshooting

DANGER
Risk of injury and machine damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
Please observe the attached document "Warranty". In the event of any doubts and/or
problems, please contact your retailer or the manufacturer.
NOTICE
• Consult the documentation for the welding components.
Problem Cause
• Power supply to the work-piece or torch
interrupted
No welding
• Power supply defective
arc
• Contactor not activated in the power
supply
• Inadequate flow of coolant
Torch body or
• Welding current too high
power supply
overheated
• Coolant hose or liquid-cooled power cable
constricted or closed.
• Tungsten electrode loose
Tab. 7 Troubleshooting
BAL.0166 • 2019-01-03
10 Troubleshooting
Solution
• Close the power circuit
• Repair
• See operating instructions for the
power supply
• Check that the re-circulating cooling
unit is working and performing
correctly
• Reduce
• Check the flow and replace if
necessary
• Tighten by means of torch cap
EN - 15