Installing the
display card in
Fronius IG / IG
Plus
(continued)
7.
8.
Erecting/connec-
The antenna is supplied with a 2 m (6.74 ft) connecting cable. If the Fronius IG / IG Plus
ting the antenna
is installed in a location that is shielded from radio waves, this cable allows the antenna
to be erected where it can receive radio waves.
FRONIUS IG Indoor wall mounting and connection:
FRONIUS IG Outdoor/FRONIUS IG US installation:
Important! Use the previously removed original housing screw to screw the antenna
mounting bracket onto the housing.
If using a Fronius IG 400/500 please install the antenna on the wall. The Cable extension
Fronius
IG 400/500
which is necessary is available at Fronius.
NOTE! The following points should be borne in mind when installing the display
card:
-
Only install the display card in the „Option 1", „Option 2" or „Option 3" slots
-
Under no circumstances should it be installed in the slot on the extreme
left, which is labelled ENS
Close the housing
Connect AC and DC lines to Fronius IG / IG Plus
1
3
2
1
5
2
1
4
2
6
1
1
3
5
4