Troubleshooting - Fronius IG 400 Manual De Instrucciones

Troubleshooting

ADD IG -- (at search mode „ADD IG")
(continued)
Cause:
Remedy:
Cause:
Remedy:
ERROR IG XX
in „ADD IG" search mode
Cause:
Remedy:
ERROR BATT
Power supply connected, battery charging
Cause:
Remedy:
FULL LIST
in „ADD IG" search mode
Cause:
No communication is possible between the personal display and the inverter
Cause:
Remedy:
Resetting the display card on the Fronius IG / IG Plus:
1.
2.
3.
Power supply to Fronius IG / IG Plus has been lost on the DC side
Check power supply of Fronius IG / IG Plus on the DC side
Old Firmware version Fronius IG / IG Plus
Update Firmware version
Fronius IG / IG Plus address number is greater than 15
Check number on the inverter and correct it if necessary.
Wrong or faulty batteries installed.
Check batteries
There are already 15 Fronius inverter in the system.
Only one personal display can ever communicate with the inverter in
the system.
If the personal display is replaced with a new one, then all the
Fronius IG / IG Plus in the system should be deleted from the perso-
nal display's configuration (see „The Setup menu", section „DEL
IG").
NOTE! If the inverters in the system have not been deleted from the configurati-
on of the personal display and if the personal display used previously is no
longer available (because of damage, for instance), then the display card in the
Fronius IG / IG Plus must be reset.
Open the setup menu and choose „DatCom"
Use arrow keys to move to the „PDCD RST" menu item
Press the Enter key to reset the display card
20