Establishing A Connection To The Inverter - Fronius IG 400 Manual De Instrucciones

Establishing a
connection to the
inverter
The personal display is now ready to display all the performance data for your installati-
on.
Important! Proceed as follows to simplify the communication configuration on systems
with several inverters:
1.
2.
3.
4.
Only connect one inverter to the mains
Reset the display card in the inverter (see „Troubleshooting")
Connect to ADD IG (see above)
Repeat this process for the other inverters
After the batteries have been installed,
„ADD IG" will appear on the screen of the
personal display.
1. If you press the Enter key the unit will
start searching for inverters. „WAIT"
will appear on the screen
2. When an inverter (e.g. IG 01) is
detected and appears on the display,
it can be added to the system by
pressing the Enter key.
Important! If an inverter is detected but
not confirmed using the Enter key, then it
is not included in the system and will not
send any performance data to the perso-
nal display.
3. This process should be repeated until
all the existing inverters have been
stored in the system.
4. Once the personal display can no
longer find a new inverter, then
„WAIT" remains displayed on the
display screen.
5. Terminate the process by pressing the
Esc button.
10