Operating Scheme; Display; Display Modes - Fronius IG 400 Manual De Instrucciones

Operating scheme

General remarks
The personal display has display modes that are similar to those of the Fronius IG / IG
Plus. A detailed description of the display values can be found in the Fronius IG / IG
Plus operating instructions.
The personal display's independent power supply enables performance data to be
retrieved even after the onset of dusk.
During the day, the default display mode for the personal display is „Now". After the
onset of dusk the Fronius IG / IG Plus will disconnect from the mains and the personal
display will switch to „Day" display mode.

Display

Press any key to activate the display. If no key is pressed for 10 seconds or more, the
display illumination will go off again.
To save battery power, the display will switch to sleep mode after a specified delay. The
display then goes off, but can be reactivated by pressing any key. The specified delay
until energy saving mode begins can be modified in the setup menu. Sleep mode can
also be switched off entirely.
For information on general display settings see the chapter entitled „The Set-up menu"

Display modes

By default, all the performance data for all the Fronius IGs / IG Plus in the system is
shown in „Now" display mode. If there is more than one inverter in the system (up to 15
are possible), then the performance data for each individual inverter can be retrieved.
The following display modes are available for performance data for:
-
-
„Now" display mode
Displays real-time values
„Day" display mode
Displays values for power fed into the mains during that day
„Year" display mode (only in conjunction with a datalogger)
Displays values for power fed into the mains during that calendar year
„Total" display mode
Displays values for power fed into the mains since the system was first commissioned
Important! If no key is pressed for 60 s, the unit will switch back automatically into
„Now" display mode and will display performance data for the entire installation.
the complete installation
each separate Fronius IG / IG Plus in the system
11