Klarstein Pure Blizzard 3 2G Manual De Usuario página 36

EN
36
Problem
Bad cooling/heating
effects
Large noise.
The compressor does not
work.
The remote control does
not work.
Display E1.
Display E2.
Display E4.
Full water indicator
illuminates
Cause
Filter mesh very dirty.
Air inlet or air outlet
clogged.
Air-conditioner not put
on a flat
surface.
Initiation of overheat
protection.
Too long a distance.
The remote control does
not point toward the
receiving head of the
remote control.
The batteries have no
electricity.
Pipe temperature sensor
failure.
Room temperature sensor
failure.
Anti-freeze protection.
The water in the baseplate
of the unit reaches the full
water level.
Remedy
Clean or replace the filter
mesh.
Remove the obstruction.
Put the air-conditioner in
a flat and firm place (may
reduce noise).
Wait 3 minutes until the
temperature decreases
and then turn on the unit.
Wait 3 minutes until the
temperature decreases
and then turn on the unit.
Bring the remote control
close to the air-conditioner
and ensure that the remote
control points toward the
receiving head of the
remote control.
Replace the batteries.
Check the pipe
temperature sensor and
related circuits.
Check the room
temperature sensor and
related circuits.
Restore the functions
automatically once
defrozen.
Drain the water in the
baseplate.