Protecting The Environment - Black and Decker V1999 H2 Manual Del Usuario

ENGLISH
Warning! Never use the appliance
without the filters. Optimum dust
collection will only be achieved with clean
filters and an empty dust bowl.
Replacing the filters
The filters should be replaced every 6 to
9 months and whenever worn or
damaged. A replacement filter (9) is
available from your Black & Decker
dealer (cat. no. WVF70):
Remove the old filters as described

above.
Fit the new filters as described

above.

Protecting the environment

Separate collection. This
product must not be disposed of
with normal household waste.
Should you find one day that your Black &
Decker product needs replacement, or if it
is of no further use to you, do not dispose
of it with household waste. Make this
product available for separate collection.
Separate collection of used
products and packaging allows
materials to be recycled and
used again. Re-use of recycled
materials helps prevent
environmental pollution and
reduces the demand for raw
materials.
Local regulations may provide for
separate collection of electrical products
from the household, at municipal waste
sites or by the retailer when you purchase
a new product.
Black & Decker provides a facility for the
collection and recycling of Black & Decker
products once they have reached the end
of their working life. To take advantage of
this service please return your product to
any authorised repair agent who will
collect them on our behalf.
You can check the location of your
nearest authorised repair agent by
8
contacting your local Black & Decker
office at the address indicated in this
manual. Alternatively, a list of authorised
Black & Decker repair agents and full
details of our after-sales service and
contacts are available on the Internet at:
www.2helpU.com.
Battery (fig. G & H)
If you want to dispose of the
product yourself, the battery
must be removed as described
below and disposed of in
accordance with local
regulations.
Warning! Disconnect the appliance from
the power supply before removing the
battery.
Preferably discharge the battery by

operating the appliance until the
motor stops.
Remove the dust bowl (3).

Using a flat-blade screwdriver, push

the battery cover (12) in at the notch
above the charger connector (9), so
that it unclips and can be removed.
Take hold of the battery casing to pull

the battery out of the appliance.
Place the battery in suitable

packaging to ensure that the
terminals cannot be short-circuited.
Take the battery to your service

agent or a local recycling station.
Warning! Once removed, the battery
cannot be refitted.