Cleaning And Maintenance; Protecting The Environment - Black and Decker VH780 Manual Del Usuario

Warning! Make sure the accessories are
securely attached before switching on.
Keep a firm grip on the appliance, and
especially the hose, when switching on
and during use.
Using the inflator adaptors (fig. H)
Choose the appropiate adaptor for

the item to be inflated.
During inflation, the airflow can be

adjusted by covering the hole (21)
with your thumb.
Do not over-inflate or exceed the

recommended pressure of the item to
be inflated.
Warning! The hole in the inflator adaptor
acts as a relief valve to prevent over-
inflating. Do not permanently cover the
hole.
Resetting the motor thermal
safeguard
The motor of the appliance is fitted with a
thermal safeguard. This device
automatically switches the appliance off
in case of overheating. If this occurs,
proceed as follows:
Switch the appliance off and remove

the plug from the wall socket.
Allow the unit to cool. When the unit

has cooled down, check and clean
the filters.
Re-insert the plug in the wall socket

and switch the appliance on.

Cleaning and maintenance

Warning! Regularly clean the filters.
Cleaning the dust bowl and filters
(fig. E & I - M)
When the dirt bowl is full or the filters are
clogged, a coloured indicator becomes
visible in the looking glass (3). When this
happens, check the appliance for clogs,
empty the dirt bowl and clean the filters.
The filters are re-usable and should be
cleaned regularly.
Press the release button (2) and

remove the dust bowl (4) (fig. I).
Empty the dust bowl.

Depress the latch (22) and remove

the filter holder (23) (fig. J).
ENGLISH
Remove the filter (24) from the filter

holder (fig. K).
Brush any loose dust off the filter.

Wash the filter in warm, soapy water.

The bowl and the filter holder can
also be washed if necessary. Do not
immerse the appliance in water.
Make sure the dust bowl, filter holder

and filter are completely dry.
Refit the filter and the filter holder

(fig. L).
Refit the dust bowl onto the

appliance. Make sure the dust bowl
clicks into place (fig. M).
Cleaning the exhaust filter (fig. E)
Open the exhaust filter holder (17).

Remove the filter from the filter holder.

Wash and dry the filter as described

above.
Refit the filter and close the exhaust

filter holder.
Warning! Never use the appliance
without the filters. Optimum dust
collection will only be achieved with clean
filters and an empty dust bowl. If dust
begins to fall back out of the appliance
after switching it off, this indicates that
the dust bowl is full and must be emptied.
Replacing the filters
The filters should be replaced every 6 to
9 months and whenever worn or
damaged. Replacement filters are
available from your Black & Decker
dealer (cat. no. VHF70).
Remove the old filters as described

above.
Fit the new filters as described above.

Storage (fig. N)
Wrap the power supply cord around

the appliance and clip the plug to the
cord.
Store the appliance in a dry location.


Protecting the environment

Z
Separate collection.
This product must not be
disposed of with normal
household waste.
7