Programming; To Erase All Codes - Craftsman 139.53910 Manual Del Propietário

PROGRAMMING
NOTICE: If this Security,l_ garage door opener is operated with a non-rolling code transmitter, the technical
measure in the receiver of the garage door opene_ which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or
supplier of the non-rolling code transmitter to circumvent that technical measure.
Your garage door opener has already been programmed at the factory to operate with your hand-held remote
control. The door will open and close when you press the large push button.
Below are instructions for programming your opener to operate with additional Security÷ _ remote controls.
To Add or Reprogram a Hand.held Remote Control
USING THE "LEARN" BUTTON USING THE PREMIUM CONTROL CONSOLE
1. Press and release the "learn"
button on the motor unit. The
learn indicator light will glow
steadily for 30 seconds.
1. Press and hold the button on the
hand-held remote* that you wish
to operate your garage door.
2. Within 30 seconds press and
2. While holding [he ENTER 3utton.
press and hold the LIGHT button
on the Premium Control Console.
hold the button on the hand-held
remote* that you wish to operate
your garage door.
3,
3. Release the button when the
motor unit lights blink. It has
learned the code. If light bulbs are
not installed. [wo clicks will be
heard
4,
Continue holding [he ENTER and
LIGHT buttons while you press
the push bar on the Premium
Control Console (all three buttons
are heldL
Release buttons when the motor
unit lights blink. It has learned the
code. If light bulbs are not
installed, two clicks will be heard.
To Erase All Codes From Motor
Unit Memory
To deactivate any unwanted remote,
first erase all codes:
Press and hold the "learn" button on
motor unit until the learn indicator
light goes out (approximately 6 seconds). All previous
codes are now erased. Reprogram each remote or
keyless entry you wish to use.
*3.Function Remotes
If provided with your garage door opener, the large
button is factory programmed to operate it. Additional
buttons on any
Security÷ _ 3-Function _
remote or compact _'_
remote Can be _ _
programmed to operate _ __
other Security.l._garage ___
door openers.
35