Nuna pipa Manual Del Usuario página 15

8 Check the installation.
a) Blue line must be level with ground.
b) Vehicle belt must be buckled, tight and locked.
c) Carrier must be stable – Carrier should not move side to
side more than 1 inch at belt path.
locking Clip Use
a) Tighten the buckled belt by pushing down hard on the
infant restraint and pulling hard on the shoulder belt.
b) While pushing down on infant restraint, pinch the two
straps together behind the buckle tongue. Unbuckle the
belt without allowing it to slip.
c) Connect lap and shoulder belts with locking clip.
d) Rebuckle belt. Check that lap belt does not move by
pulling and pushing hard on infant restraint. If belt
loosens or lengthens, repeat procedure.
1/2 inch
(12.5mm)
The locking clip should
be 1/2 inch (12.5mm)
from the buckle.
25
Installation in an Aircraft
1) Position carrier so that child is
facing the aircraft seat.
2) Route the aircraft lap belt under
both lap belt guides and buckle.
3) Adjust the angle of the carrier.
A rolled up towel or foam pool
noodle may be used to help
adjust the amount of recline.
(Page 24) The angle is correct
when the blue line is level with
the floor of the aircraft.
4) Tighten the aircraft belt while
pushing the carrier firmly into
the seat.
•
When installing in an airplane using a base, follow
the instructions for vehicle installation with a base
using lapbelt only. (Page 21)
This Child Restraint is certified for use in commercial aircraft.
Be sure to contact your airline prior to travel to discuss their
Child Restraint policy.
Installation on a Stroller
•
The Nuna Pipa car seat can attach to Nuna strollers using
adapters. Instructions are included with the adapters, which
are sold separately.
•
The Nuna Pipa can also attach to other brands of strollers
using adapters. Please visit nuna.eu for more information.
26