Nuna pipa Manual Del Usuario página 12

of a crash or sudden stop if you do not
check and verify that it is securely attached.
11 To release the car seat, pull
the car seat up while squeezing
the car seat release button
located on the base.
12 To remove the base, pull the
base backwards while pressing
the buttons on the Rigid lATCH
(lower attachments)
Base install - lap & lap/Shoulder
1 Place vehicle in park and on level ground.
19
2 Position base in a forward facing
vehicle seat. Use recline adjustment
2
to position bubble in indicator.
Adjust base so bubble touches line.
3 Use recline adjustment, if needed, to
1
achieve correct angle for installation
4 Recline adjustment snaps
into position
5 For instructions on using the stability
leg when installing the base, see stability leg section.
(Page 22)
6 Route the vehicle belt through the opening in the base
labeled 'Belt Path' and buckle the vehicle belt. Both the
shoulder AND lap belt must be under the blue lock off.
1
2
3
20