Installation Instructions - Nuna pipa Manual Del Usuario

4 Gently guide child's arms
through harness loops. Insert
buckle tonges into buckle. listen
for clicks. Pull on buckle to verify
it is latched.
5 Snap the chest clip together
and temporarily slide towards
buckle for tightening of harness.
6 Tighten harness by pulling on the adjuster strap. Pull any
excess harness webbing through the buckle towards the
child's shoulder and pull on the adjuster strap. This may
need to be repeated several times for proper fit.
7 Verify that the harness is snug around the child's waist and
shoulders.
8 Position the chest clip so it is
at child's armpit level.
15
9 Check that child is secure
a) Buckle is fastened.
b) Harness straps are not twisted.
c) Harness is snug – A snug harness cannot be pinched,
and should not allow any slack.
d) Chest clip is level with armpits.
If harness slots are not AT or BElOW
shoulder height, child could be ejected in a
crash or sudden stop. If harness slots need
to be moved, see section changing harness
slot position. (Page 12)
Make sure that nothing interferes with the
harness. Make sure harness is snug around
child and lays flat. Serious injury or death could
occur to a child that is not secured properly.
If child is not secured properly, child could
be ejected in a sudden stop or crash,
resulting in serious injury or death.
Installation
instructions
Base install - Rigid lATCH
(lower Attachments)
1 Place vehicle in park and on
level ground.
16