Selecting System Mode - Mitsubishi Electric RedLINK MHK2 Manual De Operación

Selecting System Mode

Current system mode (Heat, Cool, Dry, Fan, Auto,
Off) is displayed on the controller home screen.
The mode that's currently running (Heat or Cool) is
displayed in the upper-left corner of the controller
home screen.
To cycle through the available modes, touch Mode
on the controller home screen, and select the
appropriate mode for your desired temperature.
• Heat: Enjoy warm air at your desired temperature.
• Cool: Enjoy cool air at your desired temperature.
• Dry: Dehumidify your room. The room may be
cooled slightly. Temperature may not be settable
during DRY mode depending on your equipment.
• Fan: Circulate the air in your room.
• *Auto (Auto change over): The unit selects
the operation mode according to the difference
between the room temperature and the set temperature. During Auto mode, the unit
changes mode (Cool Ö Heat) when the room temperature is about 4 °F (2 °C) away
from the set temperature for more than 15 minutes.
• Off: Turns the heating, cooling, and fan systems of indoor unit off.
Notes:
• To set your temperature preferences in Auto mode, see page 6.
• Auto mode is not recommended if this indoor unit is connected to a MXZ type
outdoor unit. When several indoor units are operated simultaneously, the unit may
not be able to switch operation mode between Cool and Heat. In this case, the
indoor unit goes into standby mode. (Refer to table of operation indicator lamp.)
• Auto mode may not appear on the controller screen depending on your
equipment and how your controller was installed.
33-00447EFS_B.indd 7
7
Heat Auto
Leave Return
Vane
Auto
Cool
Leave Return
Vane
10/17/2019 3:22:52 PM