Installation; Mounting The Microphone - Alpine iLX-700 Guía De Referencia Rápida

Installation

Note on installation
•
Install at an angle between horizontal and 30°.
Note that installing at an angle outside of this
range will result in a loss of performance and
possible damage.
0 - 30°
•
Do not block the unit's heat sink, which would
prevent air circulation. If blocked, heat will
accumulate inside the unit and may cause a fire.
Rear of the Unit
Heat sink
Uninstalling the original car stereo
1
Uninstall the car stereo with its mounting
bracket.
2
Remove the cables and the mounting
bracket attached to the car stereo.
(The mounting bracket will be used in "Installing
the unit. " )
Owner's manual

Mounting the Microphone

For safe use, make sure of the following:
•
Location is stable and firm.
•
Driver's view and operations are not obstructed.
•
Microphone is located where the driver's voice can be
easily picked up (for example, on the sun visor).
When you speak into the microphone, you should not
have to change your driving posture. This may cause
a distraction, taking your attention away from safely
driving your vehicle. Carefully consider direction and
distance while mounting the microphone. Confirm
that the driver's voice can be easily picked up at the
selected location.
Microphone
Cable clamp
(Sold separately)
Installation
7
-EN